your mounting point position please consider the following:
- If the relay is being used to control the Auxiliary
Power Panel, terminals 1 and 2 will
need to intersect the "Live" wires path.
- If the Relay is being used to control another AC
device, please allow for that device's
"Live" wire to entre and exit your enclosure.
- The Rear panel is a heat sink and will produce heat.
- Terminals 1 and 2 are live and have no
- The relay will require a wire from the power supply
and one from the TB6560 that
you'll need to make allowance for
- Do not drape or rest
other wires on/over the Relay
template (Not to scale)
Once you have
selected the desired position to mount the AC Relay please
drill 2 x
4mm holes as per the mounting template. Relay
orientation is at your discretion but
remember the relay terminals 1 and 2 need to intersect with
the path of the "Live"
wire leading to the Auxiliary Power Panel.
Align the bottom mounting point up with the lower 4mm hole.
The lower mounting point is fixed
and the upper has some adjustment space.
bolts through the AC Relay and the mounting surface and
attach flat washer, spring washer and
nut then tighten.
Once the bolts are
tightened grasp the relay and make sure it is firmly in
The AC Relay is
You are now
ready to move onto the next step: